Triton FT5000 User Manual - Manual (Page 180)

B-2
M
ODEL
FT5000 U
SER
M
ANUAL
Rear Service Panel (RSP) Functions
The RSP provides convenient user-access to cassette close and replenishment
functions from inside the facility. It also provides diagnostic tests on the dis-
penser mechanism, ability to reset errors, and terminal shutdown. The following
describes the menu options available from the RSP unit.
1. Upon power-up, the FT5000 will
initialize and run through its internal
setup. The RSP will initially display
a screen message as shown in
Figure 1 for approximately 30
seconds, then change to a “BUSY”
status until the unit completes its
startup (Figure 2).
2. Once the FT5000 completes its
startup, the status display in the
lower left corner will change to
“IDLE” (Figure 3).
3. In the “IDLE” state, the ATM’s
Customer screen is displayed for
transactions. When ENTER is
selected from the RSP keypad, you
will be prompted to enter your
Management function password.
Figure 1. Initial screen.
Please wait.
Status: BUSY
Press ENTER to begin.
Status: IDLE
Figure 2. “BUSY” status.
Figure 3. “IDLE” status.
Note: If the status display remains on
“BUSY” after the unit completes its
startup, you may have to reboot the
unit.
Note: The Customer screen will
change its display to “This machine
is temporarily out of service. Please
wait.” It will continue this message
as long as you are accessing the RSP
functions.