ArtDio IPE 1000 User Manual
Page 27
27
PBX GATEWAY (config)#
Step 3: Enable DHCP Mode
PBX GATEWAY (config)#ip state dhcp
PBX GATEWAY (config)#
Step 4: Back to Privileged Mode
PBX GATEWAY (config)#exit
PBX GATEWAY#
Step 5: Restart the system to enable DHCP mode. After the restart command is issued, the system
will prompt for a confirmation.
PBX GATEWAY#restart
This command restarts the system. The system will now restart operation code
agent.
Reset system, [Y]es or [N]o? Yes
Using Phone Set Interface (please refer to the Phone Set Interface Configuration Procedures for
more detailed information)
Step 1: Take the handset off the phone. Step 2: After hearing the dial tone dial the PROG Access
Code.
Step 3: Enter the Password.
2
Step 4: Enter code "01" to begin configuring the DHCP state.
Step 5: Enter "1" to enable DHCP client and "#" as the ending prompt. You will then hear the
confirmation tone. (Or enter "0" to disable the DHCP client and "#" as the ending prompt).
System must now be restarted
Step 6: Enter code "98" then press "1" and "#" as the ending prompt. You will then hear
the confirmation tone, the system will then restart automatically.
Place the handset on the phone to end your configuration session.
2
The (default) password for the Phone Set Interface is "0000".