ArtDio IPE 1000 - Manual (Page 47)

47
Category Entry Description Data
Type Range
Cut
Through While access the FXO ports, in
order to dial out directly bypass to
the FXS ports of this device without
listen to the Greeting Message that
recorded in the device, then press
this Access Code. (FXO to FXS) RW [0~9,*,#][0~9],
example
"*12345"
(Default is
Blank)
Softkey
Access Define the Access Code to trigger
the soft-key defined for each
channel manually RW [0~9,*,#][0~9],
example
"*12345"
(Default is
empty)
Circuit
Connect Define the Access Code for logical
circuit-connect dialing. With this
access code plus the prefix and
port number, the port that start this
circuit connect action will
connected to the remote port
similar that there are circuit
between. RW [0~9,*,#][0~9],
example
"*12345"
(Default is
empty)
MGCP Define the Access Code to make a
call to remote MGCP registered
entries. Example: *2 is the MGCP
access code, 30002300 is the
number of entry that registered in
Call Agent. Dial "*2" first, after
hearing the dial tone, dial
"30002300" user can hear the ring
back tone that connecting to this
entry. RW [0~9,*,#][0~9],
example
"*12345"
(Default is
empty)
FXO
Outgoing
Prefix Prefix Define the prefix that whenever
dial out from FXO port, it is useful
for connecting under the lines of
PBX RW [0~9,*,#][0~9][P
13
], example
"9P"
(Default is
empty)
13 "P" in large capital means pause for one second, while connecting the voice gateway to extension lines of PBX, it will take seconds for PBX
to find an available PSTN connection for you. User can apply multiple "P" if user wants take pause for more than one second.