ArtDio IPE 1000 - Manual (Page 75)

74
Category Entry Description Data
Type Range
Password
Threshold The session will be halted if the
number of invalid password tries
has reached the threshold. Please
note that it applies only to the
console and Telnet, it does not
apply to the web interface. The
value of 0 stands for no password
threshold. RW 0 – 255
(Default:1)
Silent
Time Determines how long the console
will halt when the invalid password
tries have reached the threshold. RW 0 – 255
minutes
(Default:0)
Baud Rate System console baud rate
selection. If the baud rate is set to
any rate other then 9600 you will
see a string of garble in the
terminal during system boot up.
The console goes back to normal
after boot up. This is because the
system is set at 9600, 8, 1, N
during boot up. Therefore it is
highly recommended to configure
the system console to 9600 baud.
RW 2400,
9600,
19200,
38400
Data Bits Data bits selection RW 7, 8 bits
Stop Bits Stop bits selection RW 1, 2 bits
Access
Code The Access Code to start the
Phone Set Programming Mode
(see 5 Phone Set Interface
Configuration Procedures for more
detailed information) RW ## as default,
1-6 digits, the
first digit can
be "#" or "*" Phone Set
Programming
Password The password required to enter the
Phone Set Programming Mode
after entering the Access Code
RW 0000 as
default,
1-4 digits
User
Name The Authentication ID to begin the
Web Management Interface. The
Read & Write account can read
and write information via a Web
browser. The Read only account
can read information only. RW WEB as
default for
Read and
Write, BLANK
for read only
1-12
characters in
string format
Password The Password for the
Authentication ID to begin the Web
Management Interface
WO Empty
password as
default, Allow
string up to 6
characters
Web
Authentication
Confirm
Password Re-enter the Password for the
Authentication ID to confirm
access into the Web Management
Interface WO Empty
password as
default, Allow
string up to 6
characters