ArtDio IPE 1000 - Manual (Page 29)

29
agent.
Reset system, [Y]es or [N]o? Yes
Step 7: Configuring the Prefix for the gateway
The prefix for the gateway should be assigned by the network administrator and configured to the
device. It will be carried in the routing messages to notify the master device of its prefix for other
gateways to route its calls.
Command: PBX GATEWAY (routing)#prefix <prefix for this gateway>
PBX GATEWAY (routing)#prefix 99
PBX GATEWAY (routing)#
Step 8: Configuring the Internal Call Access code for the gateway
Command: PBX GATEWAY(routing-code)#internal_ac <Internal Calls Access code
for this gateway>
PBX GATEWAY(routing)#code
PBX GATEWAY(routing-code)#
PBX GATEWAY(routing-code)#internal_ac *
Step 9: Configuring the Extension Number Length of the PBX
Command: PBX GATEWAY(routing-code)#extension_len <length of extension number
of PBX>
PBX GATEWAY(routing)#code
PBX GATEWAY(routing-code)#
PBX GATEWAY(routing-code)#extension_len 3
(System must be restarted in order for the new configurations to take effect)
Using the Phone Set Interface (please refer to Phone Set Interface Configuration Procedures for more
detailed information)
Step 1: Take the handset off the phone.
Step 2: After hearing the dial tone, dial the PROG Access Code.
Step 3: Enter the Password.
Step 4: Enter code "06" to begin configuring the IP address of the master gateway.
Step 5: Enter the IP address for the master gateway as "0", "*", "0", "*", "0", "*", "0"