ArtDio IPE 1000 - Manual (Page 72)

71
Category Entry Description Data
Type Range
Channel The channel number. Shown
in the Group/Port format. Port
2 in group 1 will be shown as
1/2 RW Two groups
and 4 ports for
each group.
1/1
Current Codec
Type Displays the current codec in
use by the channel RO
Packet Time
(msec) Displays the current packet
time in use by the channel RO
VAD Displays VAD administrative
status RO
Echo
Cancellation Displays Echo Cancellation
administrative status RO
Jitter Buffer
(msec) Displays how long the jitter
buffer is used in this channel.
If the channel has received no
traffic, the last value that was
used by the previous call will
be displayed. 0 stands for
AUTO jitter buffer. RO
DTMF Filter Displays DTMF Filter
administrative status
Busy Time
(sec) Displays the length of time
this channel has beenbusy .
(Includes incoming and
outgoing calls.)Busy time will
be reset when you switch off
the power . RO
Reset Busy
Time Check box. If checked and the
refresh button is then clicked,
Busy Time will then be reset. RW
FXO Loop
Current Lost
Counter
19
Displays the number of
counter that FXO interfaces
can not detect loop current RO
Clear Loop
Current
Counter To reset the FXO Loop
Current Counter back to zero RW
Call Attempt Displays the number of call
attempts that have been
made. RO
Successful
Outgoing Call Displays the number of
successful outgoing calls that
have been made. RO
Incoming Call Displays the total number of
incoming calls RO
Successful
Incoming Call Displays the number of
successful incoming calls RO
19 If the counter is greater than "0", then the Red alarm LED on the front panel will be lit. After it is cleared, the Red Alarm LED will go off.