ArtDio IPE 1000 - Manual (Page 89)

88
8. Regional Tone adjustment
For most countries, the tone specifications are not the same. The differences in particular are with the
definitions for Dial Tone, Ring Back Tone, Busy Tone and Reorder Tone. In order to make the PBX gateway
capable of being installed in different countries, the device administrator can change the regional_id
according to which country the device is installed in. If he or she specifies a different regional ID, the ring,
cadence and frequency that is sent out or detected by the PBX voice gateway will be adjusted also .
The command to change the regional_id can be imputed under the Console or Telnet by CLI.
PBX Gateway>enable
PBX Gateway#config
Enter the configuration commands, one per line. End with CTRL/Z
PBX Gateway(config)#regional_id ?
<0-99> Set the value for regional id
PBX Gateway(config)#regional_id 2
PBX Gateway(config)#exit
PBX Gateway#delete nvram ?
all Select the function to delete the NVRAM
keep_ip Select the function to delete the NVRAM
<cr>
PBX Gateway#delete nvram keep_ip
(The command "delete nvram keep_ip" is functioning as the factory reset but will keep the IP
address configuration for this device and the regional_id, after doing this; you should again
re-configure the device).
After the system boot-up again, use “show run” to check the new configured regional ID.
The default value is set to "00" for the regional_id, but it may be equivalent to some of the regional_ids
listed below. This depends on which regional_id will be entered as the default value.
Regional_id Country
06
Canada
07 China
12 France
15 Hong Kong
22 Italy
23 Japan
Regional_id Country
36 Singapore
38 Slovenia
40 Spain
43 Taiwan
46 Great Britain
47 United States
Table 8-1 the table of regional IDs and their corresponding countries