ArtDio IPE 1000 - Manual (Page 32)

32
Using the System Console Interface or Telnet on the Slave Device
Step 1: Enter Privileged Mode
PBX GATEWAY>enable
Password: ******
PBX GATEWAY#
Step 2: Enter Routing Mode
PBX GATEWAY#routing
PBX GATEWAY (routing)#
Step 3: Configure this device as the master gateway
Command: PBX GATEWAY (routing)#master_ip 211.21.40.180
PBX GATEWAY (routing)#
Step 4: Configure the group ID that is used for the entire group
Command: PBX GATEWAY(routing)#group_id <the group ID for the whole group, same
value for master and slaves in the same group>
PBX GATEWAY(routing)#group_id 2000
System need to restart
PBX GATEWAY(routing)#
Step 5: Go back to Privileged Mode
PBX GATEWAY (routing)#exit
PBX GATEWAY#
Step 6: Restart the system for the new settings to take effect. After the restart command is issued, the
system will prompt for a confirmation.
PBX GATEWAY#restart
This command restarts the system. The system will now restart operation code
agent.
Reset system, [Y]es or [N]o? Yes
Step 7: Configuring the prefix for the gateway