Avigilon ACC Standard Version 5.2.2 - Manual (Page 82)

Windows Default for the Client to use the same language as the operating system.
l
Automatically log in to sites: Select this check box to automatically log in to all Sites you can
access. Select the type of login you use:
l
Select Using Windows Authentication if you use your Windows login to access Sites.
l
Select Using saved user name and password: if you use your AvigilonControl Center
username and password.
l
In the Maximum Incoming Client Bandwidth: area, you can set how much bandwidth is received by
the client. This includes video streaming.
You can select Unlimited or Other:, and specify the maximum bandwidth allowance in kilobits per
second (kbit/s).
l
In the Client Duplex Audio Setting: area, decide if you want to enable two-way audio. This allows
people in the video to talk with the operator monitoring the video.
You have the option of Full-duplex audio, which allows simultaneous communication, or Half-
duplex, which only allows communication from one side at a time. To use this feature, you need to
set up microphones and speakers to cameras. See
Microphone and Speaker for more information.
3. Click OK to save your changes.
Joystick Settings
There are two types of joysticks supported by the Client: standard Microsoft DirectX USB joysticks and the
Avigilon USB Professional Joystick Keyboard.
Access the Joystick settings to install the required drivers and configure your joystick options.
Configuring an Avigilon™ USB Professional Joystick Keyboard For Left-Hand Use
The Avigilon USB Professional Joystick Keyboard is a USB add-on that contains a joystick for controlling zooming
and panning within image panels, a jog shuttle for controlling the Timeline, and a keypad programmed with the
Client's keyboard commands. Refer to
Keyboard Commands for the keypad commands that control the Client.
By default, the keyboard is installed in right-hand mode. Change the Joystick settings to configure it for left-hand
mode.
1. Connect the keyboard.
2. In the top-right corner of the Client, select > Client Settings... > Joystick.
If the keyboard is not automatically detected, an error message will appear. Click Scan for Joysticks....
Otherwise, the following option is displayed.
82 Joystick Settings