AW Gear Meters RT-10 - Manual (Page 13)

RT‐10 Flow Monitor
Operation and Programming Manual
12
Total Display
View the Job Total using the DN/MODE button when cover is open, or externally using the magnet
switch. As the MODE changes, “total” displays briefly. The total initially displays with five decimal places.
The decimal point “floats” to the right as the total increases. The Job Total rolls over to zero when the
value reaches 999999. The RT‐10 reverts to “sleep” mode after a specific period of inactivity where the
device receives no pulses and activates no switches.
Total Reset
Reset the Job Total while it is displayed by using the UP/RESET button when cover is open, or the
magnet wand when cover is closed.
Total values are maintained and backed‐up in non‐volatile memory every 24 hours. Backup occurs when
the clock reaches 12:00 A.M. A total value accumulated since midnight is lost if you remove or change
the battery.
Grand Total Display
The Grand Total is a second totalizer. It has protection from accidental reset and an overflow counter for
a larger capacity. Press and hold the SEL button when the cover is open to view the Grand Total while
the Job Total is displayed; externally, use the magnetic switch. The Grand Total only displays as long as
you hold the button or activate the magnetic switch. The Grand Total rolls over to zero when the value
reaches 999999. An overflow counter keeps track of the number of times the Grand Total has rolled
over. You can only view the overflow counter with the cover off by pressing and holding the SEL and DN
buttons. See flow chart next page.
1 SEC
D ISPLA YS
B RIEFLY
UP
M O D E
FRO M RA TE D ISPLA Y
M O D E
TIM ER
PRESS UP TO
RESET TO TA L
SLEEP
W HEN
IN A C TIVE
TO C LO C K O R TO TA L D ISPLA Y
Notice