In-Situ TROLL Link Telemetry System Operators Manual - Manual (Page 24)

800-446-7488 24 www.in-situ.com
1. Open Win-Situ 5 Plus Software.
2. Click No when prompted Connect to device now?
3. Click Preferences.
4. Click Comm Settings...
5. Click the radio button next to Modem Communications.
6. Enter the data phone number.
7. Enter the Device Address of the instrument you intend to connect to (Default 1).
8. Enter the number of Retries (user-defined; 3 is recommended).
9. Enter a Transmission Delay value between 15 and 20.
10. Enter the TROLL Link password, if applicable.
11. Ensure the Mode is set to Modbus-ASCII.
12. Click the check mark.
13. Click the connect button in the lower-right corner.
14. Click the Logging tab, click the desired log and click Download.
15. Click the disconnect button.
Connecting to the TROLL Link 100 in TCP/IP Mode
Win-Situ 5 Plus can only establish a connection to the TROLL Link Telemetry
System during a scheduled Wake/Message period.
1. Open Win-Situ 5 Plus Software.
2. Click No when prompted Connect to device now?
3. Click Preferences.
4. Click Comm Settings...
5. Click the radio button next to IP Communications.
6. Enter the IP Address and Port Number.
The IP Address and Port Number are available (if you wrote them
down when prompted) in the section Defining the Mode of
Operation. You must reconnect to the TROLL Link Telemetry
System using the TROLL Link Setup Software and find the
numbers on the Summary Tab if you did not write the numbers
down.
7. Enter the Device Address of the instrument to connect to (Default 1).
8. Enter the number of Retries (user-defined; 3 is recommended).
9. Enter a Transmission Delay value between 15 and 20.