In-Situ TROLL Link Telemetry System Operators Manual User Manual
Page 49
800-446-7488
49
www.in-situ.com
Configuring the TROLL Link Telemetry System Using Over-Air Commands
TROLL Link Telemetry System 101 and 201 models are pre-configured to the correct
instrument types, requested parameters, and transmission interval prior to shipping.
Altering this configuration is possible, but not recommended. Increasing the number of
parameters or the transmission interval may result in data overage charges if the
increased data transmission exceeds the purchased data plan. Consult In-Situ Inc. prior
to altering the original configuration to avoid data overage charges.
The TROLL Link Telemetry System is configured using over-air commands from the
Data Center.
Access the Data Center.
1. Open a Web browser.
2. Enter the URL: http://www.isi-data.com
3. Enter your User ID and Password.
4. Click Login. The Site Index screen appears.
Change transmitted parameters for each instrument.
1. Click Manage Site. The Configuration Screen appears.
2. Click the plus sign next to your site name (the name may be Default). The site menu
expands and instruments in your site are displayed below the Assign Devices
entry. Instrument names may be a series of numbers.
3. Click the first instrument listed.
4. Click Over-Air Commands under the Device Config heading in the left sidebar.
5. Click the Add or Remove check box next to the parameter name to change the
transmitted parameters. All parameters are transmitted under default settings.
6. Click the Send Config button. You may need to scroll to view the button.
7. Click the site name in the left navigation window.
8. Click Manage Site under the Site Management menu in the left navigation window.
9. Repeat steps 2 through 8 for the remaining instruments in your site.
Change the transmission interval for the site.
1. Log in to the Data Center if you have not already done so.
2. Follow steps 1 through 4 of the previous instruction set to access the Over-Air
Commands.
3. To change the transmission interval, click the arrow button next to Update
transmission interval, and select Yes.
4. Click the arrow button next to Base message interval and select the desired
interval rate.