In-Situ TROLL Link Telemetry System Operators Manual - Manual (Page 31)

800-446-7488 31 www.in-situ.com
3. Strip the cable ends to 1.3 cm (0.5 inches).
4. Insert the solar panel cable into the dome connector cap, and then through the
enclosure.
5. Connect the black lead (negative) from the solar panel to the screw terminal labeled
"SOLAR-". Tighten the screw terminal.
6. Connect the white lead (positive) from the solar panel to the screw terminal labeled
"SOLAR+". Tighten the screw terminal.
7. Tighten the dome connector cap to ensure that the port with the cable is watertight.
Connecting the TROLL LINK to the External Battery Kit Enclosure
1. Remove two dome connector caps, one from the outside of the battery kit enclosure,
and one from the TROLL Link Telemetry System. Remove the port plugs. Save the
plugs for later use.
2. Insert the separate power cable shipped with the external battery kit into one dome
connector cap, and then through the battery kit enclosure.
3. Connect the black lead (negative) of the cable to the "BATT-" screw terminal of the
battery box.
4. Connect the white lead (positive) of the cable to the "BATT+" screw terminal of the
battery box.
5. Insert the other side of the cable through the remaining dome connector cap. There
should be two dome connector caps on the cable, oriented in opposite directions.
6. Insert the cable through the dome connector to the inside of the enclosure.
7. Connect the black lead (negative) of the external battery kit cable to the "SOLAR-"
screw terminal of the enclosure.
8. Connect the white lead (positive) of the external battery kit cable to the "SOLAR+"
screw terminal of the enclosure.
9. Tighten all dome connector caps so the ports with cable are watertight.
Turning Off the Modem
1. Disconnect the white wire from the SOL+ screw terminal.
2. Disconnect the red (positive) lead from the red battery terminal.
3. Disconnect the black (negative) lead from the black battery terminal.