In-Situ TROLL Link Telemetry System Operators Manual - Manual (Page 35)

800-446-7488 35 www.in-situ.com
Updating the Firmware - TROLL Link 100 Only
Updating the firmware and cycling the power (turning the system off and then turning it
back on) resolves some issues.
1. Connect the TROLL Link Telemetry System to your PC.
2. Connect power to the TROLL Link.
3. Launch the TROLL Link Setup Software.
4. Click File, and then click Update Firmware...
5. Ensure the COM shown in the Port drop-down menu is correct.
6. Follow the onscreen instructions.