Jenway Genova Nano English - Manual (Page 4)

2
Contents
Page
SECTION 1 - INTrOduCTION 3
1.1 MICRO VOLUME ACCESSORY DESCRIPTION 3
1.2 MICRO VOLUME ACCESSORY SPECIFICATION 3
1.3 UNPACKING 4
SECTION 2 – ACCESSOry LAyOuT ANd INSTALLATION 5
2.1 ACCESSORY LAYOUT 5
2.2 ACCESSORY REMOVAL 5
2.3 ACCESSORY INSTALLATION 7
2.4 INITIALISATION 7
SECTION 3 – ACCESSOry SETTINGS 8
3.1 ACCESSING THE MICRO VOLUME ACCESSORY SETTINGS 8
3.2 PATH LENGTH SELECTION 9
3.2.1 Known Path Length Measurements 9
3.2.2 Unknown Path Length Measurements 9
SECTION 4 – PErFOrMING MICrO VOLuME MEASurEMENTS 10
4.1 PIPETTING SAMPLES ONTO THE MICRO VOLUME READ HEAD 10
4.2 SAMPLE RECOVERY OR REMOVAL 11
SECTION 5 – CALIBrATION OF THE MICrO VOLuME ACCESSOry 12
5.1 CALIBRATION SOLUTIONS (035 092) 12
5.2 ACCESSORY CALIBRATION PROCEDURE 12
5.2.1 Micro Volume Accessory Settings 12
5.2.2 Calibration Standard - Data Entry 12
5.2.3 Accessory Calibration and Verification 13
SECTION 6 – CLEANING ANd dECONTAMINATION OF THE MICrO VOLuME ACCESSOry 16
6.1 ACCESSORY CLEANING 16
6.2 ACCESSORY DECONTAMINATION 16
6.3 READ HEAD RECONDITIONING 16
SECTION 7 – ACCESSOrIES 16
7.1 ACCESSORIES 16
SECTION 8 – MAINTENANCE ANd SErVICE 17
8.1 ROUTINE MAINTENANCE 17
8.2 SERVICE 17
SECTION 9 – TrOuBLESHOOTING 18
9.1 ACCESSORY ERROR CODES 18
9.1.1 Calibration Procedure Error Codes 18
9.1.2 Verification Check Error Codes 18
9.2 TROUBLESHOOTING GUIDE 19
9.3 TECHNICAL SUPPORT 19
SECTION 10 – GLOSSAry OF ICONS 20
SECTION 11 – CHEMICAL COMPATIBILITy 21