Jenway Genova Nano English - Manual (Page 9)

7
Carefully lift the micro volume accessory from the spec-
trophotometer sample chamber by rotating the acces-
sory towards the right hand side so that the highlighted
detector optic is not knocked during the removal of the
accessory.
Finally disconnect the power and communication
cable from the underside of the
accessory PCB.
2.3 ACCESSOry INSTALLATION
The micro volume accessory is installed by reversing the procedure described in Section 2.2.
2.4 INITIALISATION
Connect the power supply unit to the power inlet socket on the rear panel of the instrument and
connect to the mains socket. Turn the power on at the mains and switch the instrument on using the
power switch on the rear of the instrument.
The instrument will initially check for firmware updates and then perform several power-on tests before
displaying the main menu:
Fig 2.2 – Genova Nano Main Menu
11
Finally disconnect the power and communication cable
from the underside of the accessory PCB.
2.3 ACCESSORY INSTALLATION
The micro volume accessory is installed by reversing the procedure described in Section 2.2.
2.4 INITIALISATION
Connect the power supply unit to the power inlet socket on the rear panel of the instrument and
connect to the mains socket. Turn the power on at the mains and switch the instrument on using the
power switch on the rear of the instrument.
The instrument will initially check for firmware updates and then perform several power-on tests
before displaying the main menu:
Fig 2.2 – Genova Nano Main Menu
Rotate the
accessory to the
right to remove.
Detector optic