Pyromation Series 610 1_16 DIN - Manual (Page 42)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
6 Messages and Error Indications
The following displays are shown when an error occurs or a hardware change is detected.
Table 4. Error/Faults conditions
Error/Faults Conditions Upper display Lower Display
(where fitted)
1 /
8
DIN Indicator
Units Display
Configuration & Setup is required.
Seen at first turn on or if hardware
configuration changed.
Press to enter Configuration
Mode,
next press or to enter the
unlock code number,
then press to proceed.
Configuration must be completed
before return to operator mode is
allowed
1
# / 

(# / for 1
second, then
3 C" on
Indicators)
3 C" 3
Input more than 5% over-range 2
2
$$
9 * Normal Display Normal Display
Input more than 5% under-range 3
2
''
9 *
Normal Display Normal Display
Sensor Break. Break detected in
the input sensor or wiring ) (

*
 Normal Display Normal Display
Auxiliary input over-range Normal Display
2
$$
9 * n/a
Auxiliary input under-range Normal Display
2
''
9 *
n/a
Auxiliary Break. Break detected in
the auxiliary input Normal Display
) (

*  n/a
Option 1 module fault. **** @C 
Option 2 module fault. **** @C 
Option 3 module fault. **** @C 
Option A module fault. **** @C  
Option B module fault. ** @C 
* Note
Input sensor and Auxiliary over/under-range or break indications will be seen wherever
these values would normally be displayed.
** Note
Option module number follows error legend on 1 /
16
DIN Indicators (e.g. **)
59305, Issue 6 – March 2006
Powering Up Page 37
1 This feature does not guarantee correct configuration. It only helps to ensure that the unit will be configured
before use. Use of set-up mode is not enforced but may be essential for the users application.
2 If the PV display exceeds  before 5% over-range is reached, an over-range indication is given.
3
Indicators will allow up to 10% under-range on non-zero based Linear ranges. If the PV display is less than
 before the % under-range is reached, an under-range indication is given.