Pyromation Series 610 1_16 DIN - Manual (Page 59)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
P6100, P8100 & P4100 Controllers - Operator Mode
This is the mode used during normal operation of the instrument. It can be accessed from
Select Mode, and is the usual mode entered at power-up. The available displays are
dependent upon whether Dual or Remote Setpoint modes are being used, whether Setpoint
Ramping is enabled and the setting of the Display Strategy parameter in Configuration Mode.
Note:
For model P6120 only the Initial Operator Mode screen is available.
WARNING:
IN NORMAL OPERATION, THE OPERATOR MUST NOT REMOVE THE CONTROLLER FROM
ITS HOUSING OR HAVE UNRESTRICTED ACCESS TO THE REAR TERMINALS, AS THIS
WOULD PROVIDE POTENTIAL CONTACT WITH HAZARDOUS LIVE PARTS.
CAUTION:
Set all Configuration Mode parameters and Set Up Mode parameters as required
before starting normal operations.
P6100, P8100 & P4100 Controllers – Extended Operator Mode
Using the PC configuration software, it is possible to extend the Operator Mode displays
available by adding parameters from Setup Mode. When an extended Operator Mode is
configured the additional parameters are available after the standard operator displays.
Note:
This mode is not applicable to the P6120.
Navigating in Operator Mode
Press to move between displays.
When a display value can be adjusted, use or to change its value.
Note:
The operator can freely view the parameters in this mode, but alteration depends on the
settings in the Configuration and Set Up Modes. All parameters in Display strategy 6 are
read only, and can only be adjusted via Setup mode.
Page 54
P6100, P6120, P8100 & P4100 Model Group 59305, Issue 6 – March 2006