Pyromation Series 610 1_16 DIN - Manual (Page 146)

1 /
4
-DIN, 1 /
8
-DIN & 1 /
16
- DIN Controllers & Indicators - Product Manual
Elapsed Time Type: Indicator Definition
The total accumulated time that Alarm 1 has been active on an Indicator since this parameter
was last reset. This does not include the time when the alarm condition has cleared. The
Elapsed Time is not affected by the Alarm 2 and Alarm 3 status.
Also refer to Alarm Operation, Exceed Time and Indicator.
Exceed Condition Type: Limit Controller Definition
A state that occurs when the Process Variable exceeds the Limit Setpoint value. E.g. if the
PV is above the Limit SP when set for high limit action, or below the Limit SP for low limit
action. The Limit Controller will shut down the process when this condition occurs, and
cannot be reset until the Exceed Condition has passed.
Also refer to
and Limit Setpoint.
Input Filter Time Constant Type: General Parameter
Annunciator, Exceed Time, Latching Relay, Limit Controller, Limit Hysteresis
Exceed Time Type: Limit Controller Definition
The total accumulated time that a Limit Controller has been in the Exceed Condition since
this parameter was last reset.
Also refer to Elapsed Time, Exceed Condition and Limit Controller.
Indicator Type: Indicator Definition
An instrument that can display a Process Variable. Alarm outputs are available that will
activate at preset PV values. Relay outputs can be selected to have a Latching function
similar to a Limit Controller output, but indicators do not have the necessary approvals for
safety critical applications. Other options are PV retransmission and Serial Communications.
Process control functions are not available.
Also refer to Alarm Operation, Controller, Elapsed Time, Latching Relay, Limit Controller,
Multi-Point Scaling, Process Variable, Retransmit Output, Serial Communications, Tare.
This parameter is used to filter out extraneous impulses on the process variable. The filtered
PV is used for all PV-dependent functions (display control, alarm etc). The time constant is
adjustable from 0.0 seconds (off) to 100.0 seconds in 0.5 second increments.
Display code =
"'/ , Default value = 2.0 seconds.
Also refer to Process Variable.
Input Range Type: General Definition
This is the overall process variable input range and type as selected by the %C)/ parameter
in Configuration Mode.
Also refer to Input Span.
Input Span Type: General Definition
The measuring limits, as defined by the Scale Range Lower and Scale Range Upper Limits.
The trimmed span value is also used as the basis for calculations that relate to the span of
the instrument (E.g. controller proportional bands)
Also refer to Input Range, Scale Range Lower Limit and Scale Range Upper Limit.
Integral Type: Controller Tuning Parameter
Refer to Automatic Reset.
59305, Issue 6 – March 2006
Glossary Page 141