SHIMPO DEG-2000 - Manual (Page 16)

14
6.4 Setting
The set value is entered and changed in the set mode.
6.4.1 Set mode
The set mode covers the following settings:
[XDUCER]
The sensitivity of the detector is set. Refer to “Set mode (2)” in “13. Operation flow”.
[MASTER]
The master input channel and the maximum and minimum master values are set. Refer
to “Set mode (3)” in “13. Operation flow”.
[ITEM]
The item constitutive data, measuring function, number of ranks, and boundary values
(upper/lower limits) are set. Refer to “6.4.2 Measuring functions”, “Set mode (4)” in “13.
Operation flow” and “Set mode (5)” in “13. Operation flow”.
[COMM]
Input/output data, like A/D external input and judgment result output data, are set.
Refer to “Set mode (6)” in “13. Operation flow”.
[SYSTEM]
The mastering and automatic measuring functions are set. Refer to “6.4.3 Automatic
measuring functions” and “Set mode (7)” in “13. Operation flow”.
6.4.2 Measuring functions
The measuring functions are set with [ITEM]–[FUNCTION] in the set mode. Here is
described [ITEM], centering on [FUNCTION].
[STRUCT]
The constitutive data of each item and the coefficient of each constitutive data are set.
[FUNCTION]
The measuring function of each item is selected.
When “+PEAK”, “–PEAK”, “TIR”, and “TIR/2” are selected, the automatic measuring
functions are enabled. Refer to “6.4.3 Automatic measuring functions” and “Set
mode (7)” in “13. Operation flow”.
When the constitutive data of Item 1 are MAS 1 and MAS 2…
➀ Select “BYPASS”.
The measured value of Item 1 is (MAS 1 + MAS 2).
➁
Select “+PEAK”.
The measured value of Item 1 is the maximum value of (MAS 1 +
MAS 2).
➂
Select “MAX”.
The measured value of Item 1 is the larger measured value of
(MAS 1 and MAS 2).
Example