SHIMPO DEG-2000 - Manual (Page 31)

29
7.3.11 BCD output –– Input/output signal arrangement (option)
The BCD input/output signal is output when “ITEM 1”, “ITEM 2” or “ITEM 3” is selected
with [BCD OUT] or a BCD item bit is entered in the set mode (6).
Note: “Item” refers to “ITEM” of DEG2000. The following table shows the
input/output signal arrangement of the DC input/output connector
(refer to ◯
16 on page 7).
Pin No. Signal name Description
7
BCD item bit (less
significant)
Specifies measurement item to be BCD output.
8
BCD item bit (more
significant)
Specifies measurement item to be BCD output.
9 +COM
10 +COM
Input common line: +12/24 V
11 BCD OUT 1
12 2
13 4
14 8
15 10
16 20
17 40
18 80
19 100
20 200
21 400
22 800
23 1000
24 Decimal place (0)
25 (1)
26 POL +: Off, -: On
27
28
29
30
31
32
33
34
35
-COM
36 -COM
Output common line: 0 V