Techne TC-3000X - Manual (Page 30)

To save the program
[ to save ]
[ YES or NO ]
To give a program a name
A new name can now be given to the copied
program (see below).
To type in a name for the program, press
"Enter" and a cursor will appear in the
position shown.
Using the keypad, type in the name you wish
to give the program.
The letters will scroll round with successive
presses; for example the "2" key will give 'A'
with one press; 'B' with two presses; 'C' with
three presses and '2' with four presses. Five
presses will again give 'A'.
When the name is complete, press "Enter"
There are now two options:
1. Save the program and run it as it is or
2. Edit the program then save and run it.
A program can only be run once it has been
saved. Press the "End" key.
The prompt line will flash between 'SAVE?'
and 'YES or NO'.
Press "Enter" for 'Yes' to save the changes
you have made.
If you press "End" for 'No' then all the
changes you have made will be lost.
The program is now ready to run and will be
allocated with a unique 'Speed dial' number
which can be used to rapidly locate the
program from the main start-up screen.
“Up Arrow” or “Down Arrow” keys
to scroll through the remaining list of options.
28
UNNAMED #
Heated Lid 105°C
Preheat Lid on
[ , to edit ]
UNNAMED #
Heated Lid 105°C
Preheat Lid on
[ , to edit ]
DONNA
Heated Lid 105°C
Preheat Lid on
[ , to edit ]
7
pqrs
8
tuv
9
wxyz
0
4
ghi
5
jkl
6
mno
1 2
abc
3
def
DONNA
Heated Lid 105°C
Preheat Lid on
[ SAVE? ]
DONNA [7]
Run Program
View Program
[ , to select ]