Techne TC-3000X - Manual (Page 33)

[ Yes or No ]
To delete a selected program
31
OPTION 2: CREATING A NEW PROGRAM
A second option is to create a completely new program without using templates.
If you select 'Copy program' a screen similar to
this will appear and the software will
automatically give the program the next
number until it is named.
Press "Enter" and type in a new name. You
will then be able to edit the program as
previously described.
If you select 'Delete program' a screen similar
to this will appear.
Press "Enter" to delete the program or
"End" to return to the program screen.
If you want to password protect the program
so that other users cannot edit it, select 'Set
password'. A screen similar to this will appear.
Type in the password you wish to give it and
press "Enter" . The program list will then
display the key symbol next to the name to
show that it is locked. Other users will still be
able to copy/view your program but not edit it.
A number of typical values are pre-entered
including:
Heated lid temperature
Preheat lid
Sample cooling (TC-3000 shown in diagram)
Initial denaturation
Hot start
Final extension
Final hold
These values can be edited and the additional
stages and steps required for cycling can be
added by following the instructions detailed on
the following pages.
UNNAMED #
Heated Lid 105°C
Preheat Lid on
[ , to edit ]
DONNA
delete program
SURE?
DONNA
New passwd
[ to accept ]
UNNAMED #
Heated Lid 105°C
Preheat Lid on
Pause off
-------------------------
In denat 94.°C 5m00
Hot Start off
-------------------------
Final Extn 72.0°C 5m00
Final hold 10.0°C
To copy a selected program
To set a password for a selected program
[ to save ]
[ to exit ]