Techne TC-3000X - Manual (Page 45)

43
The complete list of settings is given here.
Auto restart "on" will allow the unit to restart
from where it left off should there be a power
failure and the power returns.
The "Comms address" refers to the location of a
unit in a daisy chain and must be unique if there
are several units linked to each other.
The optimum "Coms speed" is set at 4800. When
using the Gensoft control software, ensure all
cyclers are set to the same value.
Edit any line as described for 'Program defaults'
above. Press "Enter" to accept the new value.
When you have finished, press the "Enter" key
to go back to the 'Configuration' menu.
The 'Passwords' function allows the administrator
to change the 'Admin password' (which allows
access to Configuration) and also to delete any
passwords associated with programs.
Highlight 'Passwords' then press "Enter"
The screen will appear as opposite.
We suggest that you change the 'Admin password'
at this stage in order to protect the configuration
settings.
Use the "Up Arrow" key to highlight 'Admin
passwd
'Press "Enter" and type in the new password.
Repeat to confirm and accept.
The screen will go back to the 'Configuration'
menu.
To delete a password associated with a program,
use the "Up Arrow" and "Down Arrow"
keys to highlight the program.
Press "Enter"
Press "Enter" again to delete the password.
Passwords
Set date x x / x x / x x
Set time x x : x x
Date format dmy
Auto restart on
Beeper on
Coms address 1
Coms speed 4800
[ , to select ]
Program defaults
Settings
Passwords
Controller reset
* * Admin passwd * *
DONNA
GEORGE
[ , to select ]
* * Admin passwd * *
DONNA
GEORGE
[ DEL PASSWORD? ]
ADMIN PASSWD
Password
Confirm
[ to accept ]
[ Yes or No ]