Techne TC-3000X - Manual (Page 42)

[ to CONTINUE ]
[ for info ]
During the run the LCD screen will report:
1. The cycle number
2. The time remaining (counting down in
seconds)
3. The sample temperature (whether holding
or ramping)
4. The current step of the run
5. A count down of the hold time.
An example is shown here.
To pause a program while it is running, press
"Pause" The run will continue but the
prompt line will alternate 'PAUSE?' and 'YES
or NO'
To confirm that you want the program to
pause press "Enter"
If you have pressed the "Pause" key by
mistake and you want the program to
continue, press "End"
The unit will emit a beeping sound while
paused.
To resume the run, press "Pause"
followed by "Enter" to continue.
To stop a program while it is running, press
"End"
The run will continue but the prompt line will
alternate 'STOP PROGRAM?' and 'YES or NO'
To confirm that you want to stop the program
press "Enter"
If you have pressed the "End" key by
mistake and you want the program to
continue, press "End" again.
When a program is stopped the unit will emit
a beeping sound and the original program
screen will appear.
40
Manual pause
Manual stop
Cycle 4/30 56m08
Sample 58.0°C
Hold @ 58.0°C 00m17
[ to STOP ]
Cycle 24/30 19m26
Sample 72.0°C
Hold @ 72.0°C 00m10
[ PAUSE? ]
Cycle 24/30 19m26
Sample 72.0°C
Paused
[ to STOP ]
Cycle 24/30 10m39
Sample 94.0°C
Hold @ 94.0°C 00m10
[ STOP PROGRAM? ]
[ Yes or No ]
[ Yes or No ]
[ to PAUSE ]
[ for info ]