Techne TC-3000X User Manual
Page 5
the On/Off switch) is set to the appropriate voltage for the local supply. Please note that the unit must
be earthed to ensure proper electrical safety. (The TC-3000X has a switch-mode power supply which
is suitable for use with universal AC input voltages between 90 and 260V. It is not necessary to change
the fuses when using the TC-3000X). Connect the mains cable to a suitable plug according to the table
below.
Connections
220V-240V, 50/60Hz Supply
110V-120V, 50/60Hz Supply
Live
brown
black
Neutral
blue
white
Earth
green/yellow
green
3. UK ONLY: The fused plug supplied with the mains cable is fitted with a 10 Amp fuse to protect the
instrument and the user.
4. TC3000 units showing 230V, 50/60Hz on the rating plate also operate between 210 and 260V; units
with 115V, 50/60Hz also operate between 110 and 130V and units marked with 100V will operate
between 90 and 110V. In all cases the heating rate will degrade by approximately 8% at the extremes
of the voltage range.
5. Plug the mains cable into the socket on the back of the instrument.
6. Place the unit on a suitable flat bench or in a fume cupboard if required, ensuring that the air inlet
vents on the underside are free from obstruction. Position the instrument with a minimum distance all
round of 200mm from walls or other items and between each unit if multiple units are being used to
permit efficient air flow for each instrument.
7. Switch on the instrument:
I
mains switch On
O mains switch Off
Replacement cable
Should the mains lead need replacement, a cable of 1mm
2
of harmonized code H05VV-F connected to
an IEC320 plug should be used. IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN.
WORKING CONDITIONS
The thermal cycler is designed operate under the following conditions:
• Indoor use
• Ambient temperature range +5°C to +40°C
• Altitude to 2000m
• Mains supply fluctuations not exceeding 10%
• Over voltage category II IEC 60364-4-443
• Pollution degree 2
Note: The control specifications are quoted at an ambient temperature of 20°C. The specification may
deteriorate outside an ambient temperature of 10°C to 30°C.
The instrument has been tested for radio frequency interference and is certified under EN61326.
3