Takagi T-M32 - Manual (Page 45)

- 45 -
OPTIONAL ITEMS
1. TM-RE30 Temperature Remote Controller
The TM-RE30 Temperature Remote
Controller has two functions. It allows
the output temperature from the T-
M32 to be adjusted within the range
of 100 °F to 185 °F, and it also works
as a diagnostic tool that will give a
concise error code whenever there is a problem with
the unit. The temperature options are 100°F, 105°F,
110°F, 115°F, 120°F, 125°F, 130°F, 135°F, 140°F,
145°F, 150°F, 155°F, 160°F, 165°F, 170°F, 175°F,
180°F and 185°F. See the trouble shooting section for
information on possible error codes.
2. TM-MC01 Multi system controller
The TM-MC01 is the multi- system
controller for the T-M32. This can
control a maximum of 20 T-M32’s,
from 24,000 BTU to 4,800,000
BTU. It also works as a diagnostic
tool that will give a concise error
code whenever there is a problem
with the unit. Usage of the TM-
MC01 requires having the TM-
RE30.
3. TK-BF01 Backflow preventer
The TK-BF01 Backflow preventer
prevents the backflow of air through
the exhaust vent. This helps prevent
harmful exhaust gases from entering
the home, as well as helping to
prevent the unit from freezing in areas where cold
air can be blown or drawn into the exhaust
system. Install this vent damper in accordance
with Takagi’s installation instructions, and any
applicable codes.
4. TM-VC32 Vent Cap
The TM-VC32 Vent Cap is for
outdoor installation with the
T-M32 water heater. The cap
is installed on the top of the
unit, instead of connecting an
exhaust vent pipe. The cap
will prevent any debris that might be in the
environment from entering the unit and causing
damage or a fire hazard, as well as preventing
rain or other weather from entering the unit.
5. TM-DV32 Direct Vent Kit
This kit can be used convert the
T-M32 from a conventional vent
system to a direct vent (or
sealed combustion) system.
This is a CSA tested conversion
kit. Install this conversion kit in
accordance with Takagi’s installation instructions
and any applicable codes.
6. TM-PC32 Pipe cover
The TM-PC32 Pipe cover protects
the plumbing pipes to the T-M32
from unexpected adjustments.
This pipe cover is fixed to the
bottom of the T-M32, which hides
the plumbing and improves the
visual aspects of the whole installation for the
water heater.
7. TK-KPWL4 and TK-KPWH4 T-Vent Wall thimble with Termination
These terminations are used when venting out through the wall and are
compatible with the T-Vent pipe system.
These terminations are special stainless steel vents for gas appliances and
are UL listed as Category II, III and IV. There are two types of terminations:
the Louver termination and the Hood termination. For different wall
thicknesses, there are 3 ranges of lengths available (refer to the T-Vent
brochure for details).
Install these vent terminations in accordance with Takagi’s installation
instructions and any applicable local codes.
TK-KPWL4
Louver
Termination
TK-KPWH4
Hood
Termination