Brother MFC-9420CN - Manual (Page 127)

Chapter C
C - 2
Data Remaining Print data is left in the machine’s
memory. Re-start printing from your computer.
Print data is left in the machine’s
memory. The interface cable was
unplugged while the computer was
sending the data to the machine. Press Job Cancel. The machine will cancel the job
and clear it from the memory. Try to print again.
Disconnected The other person or other person’s fax
machine stopped the call. Try to send or receive again.
Document Jam The document was not inserted or fed
properly, or the document scanned
from the ADF was too long. See Document jams on page C-6.
See Using the ADF (automatic document feeder) on
page 2-10.
DR Mode in Use The machine is set to Distinctive Ring
mode. You can not change the
Receive Mode from Manual to another
mode. Set Distinctive Ring to Off.
See Turning off Distinctive Ring on page 7-8.
Near Waste Toner The waste toner pack is nearly full. Replace the waste toner pack. (See Replacing the
waste toner pack on page C-32.)
No Fusing Unit The fusing unit was not detected. Please install one. (See Fusing unit on page C-35.)
No OPC Belt The OPC belt cartridge is not installed. Install the OPC belt cartridge. (See Replacing the OPC
belt cartridge (OP-4CL) on page C-33.)
No Paper Fed #1
No Paper Fed #2
The machine is out of paper or paper
is not properly loaded in the indicated
paper tray. Refill the paper in the paper tray, and then press
Black Start or Color Start.
—OR—
Remove the paper and load it again, and then press
Black Start or Color Start.
No Response/Busy The number you dialed does not
answer or is busy. Verify the number and try again.
No Toner X
X = C, M, Y, K
(C: Cyan,
M: Magenta,
Y: Yellow, K: Black)
The toner cartridge is not installed
properly. Reinstall the X toner cartridge. (See How to replace a
toner cartridge on page C-30 and follow the steps for
properly taking out and inserting the cartridge.)
No TR Roller The transfer roller is not installed. Install the transfer roller. (See Replacing the transfer
roller on page C-39 and follow the steps for properly
installing the roller.)
Not Registered You tried to access a One-Touch or
Speed Dial number that is not
programmed. Set up the One-Touch or Speed Dial number.
(See Storing One-Touch Dial numbers on page 7-3
and Storing Speed-Dial numbers on page 7-4.)
ERROR MESSAGES
ERROR MESSAGE CAUSE ACTION