Brother MFC-9420CN - Manual (Page 34)

Loading paper and documents
2 - 10
2
Note
When you put paper in the paper tray, please
remember the following:
■
Check that the paper is flat in the tray and
below the maximum paper mark, and that
the paper guides are touching the sides of
the paper stack.
■
The side to be printed on must be face up.
Printing on envelopes
Adjust the paper length and width guides to fit
the envelopes that are going to be used.
You can load envelopes into the standard
paper tray only.
Loading documents
You can send a fax, make copies, and scan
from the ADF (automatic document feeder)
and from the scanner glass.
Using the ADF (automatic
document feeder)
The ADF can hold up to 35 pages and feeds
each sheet individually. Use standard 20 lb
(80 g/m
2 ) paper and always fan the pages
before putting them in the ADF.
■
Make sure documents written with ink are
completely dry.
■
Documents to be faxed must be from
5.8 to 8.5 in. (147.3 to 215.9 mm) wide
and 5.8 to 14 in. (147.3 to 356 mm) long.
CAUTION
■
DO NOT leave thick documents on the
scanner glass. If you do this, the ADF
may jam.
■
DO NOT use paper that is curled,
wrinkled, folded, ripped, stapled,
paper-clipped, pasted or taped.
■
DO NOT use cardboard, newspaper or
fabric.