AIS Router AI2524 - Manual (Page 247)

Chapter 11: AI2524 Sync PPP Configuration Steps
August 1997 Page 11-21
2524UM
4. (Optional) Specify a dialer idle timeout.
dialer idle-timeout seconds
5. Specify the dialer load threshold for bringing up additional WAN
links.
dialer load-threshold load
6. Configure the ISDN interface to call the remote site.
dialer map protocol next-hop-address [name
hostname ] [spc] [speed 56 | 64] [broadcast]
[ dial-string [: isdn-subaddress ]]
7. Add the interface to a dialer rotary group.
dialer-group group-number
8. (Optional) Enable PPP authentication.
ppp authentication pap
9. Enable Multilink PPP on the dialer rotary group.
ppp multilink
If you do not use PPP authentication procedures, your telephone ser-
vice must pass caller ID information. The load threshold number is re-
quired.
When Multilink PPP is configured and you want a multilink bundle to
be connected indefinitely, use the
dialer idle-timeout com-
mand to set a very high idle timer.
The dialer-load threshold 1 command does not keep a mul-
tilink bundle of n links connected indefinitely, and the dialer-
load threshold 2 command does not keep a multilink bundle of
two links connected indefinitely.