AIS Router AI2524 User Manual
Page 45
Chapter 4: Understanding the User Interface
August 1997
Page 4-9
2524UM
You can also enter ROM monitor mode by entering the
reload
EXEC command and then pressing <Break> during the first 60 sec-
onds of system startup. To save changes to the configuration file, us
the
copy running-config startup-config
command be-
fore issuing the
reload
command.
:
> ?
$ state
Toggle cache state (? for help)
B [filename] [TFTP Server IP address | TFTP Server Name]
Load and execute system image from ROM or from TFTP server
C [address]
Continue execution [optional address]
D /S M L V
Deposit value V of size S into location L with modifier
E /S M L
Examine location L with size S with modifier M
G [address]
Begin execution
H
Help for commands
I
Initialize
K
Stack trace
L [filename] [TFTP Server IP address | TFTP Server Name]
Load system image from ROM or from TFTP server, but do not begin execution
O
Show configuration register option settings
P
Set the break point
S
Single step next instruction
T function
Test device (? for help)
Deposit and Examine sizes may be B (byte), L (long) or S (short).
Modifiers may be R (register) or S (byte swap).
Register names are: D0-D7, A0-A6, SS, US, SR, and PC
To return to user EXEC mode, type
continue
. To initialize the
router or access server, enter th
i
command. Th
i
command causes
the bootstrap program to reinitialize the hardware, clear the contents
of memory, and boot the system. (Use the
i
command before you run
any tests or boot the software.) To boot the system image file, use the
b
command.