Examples: static address mapping, Examples: static address mapping -4 – AIS Router AI2524 User Manual
Page 320
AI2524 Router Card User’s Manual
Page 13-4
August 1997
2524UM
To establish static mapping according to your network needs, perform
one of these tasks in interface configuration mode:
z
Define the mapping between a next hop protocol address and the
DLCI used to connect to the address.
frame-relay map
protocol
protocol-address
dlci [broadcast] [ietf] [cisco]
z
Define a DLCI used to send International Organization for Stan-
dardization (ISO) Connectionless Network Service (CLNS)
frames.
frame-relay map clns dlci [broadcast]
z
Define a DLCI used to connect to a bridge.
frame-relay map bridge dlci [broadcast]
[ietf]
Use these keywords to specify the protocols:
z
ip
—IP
z
ipx
—Novell IPX
z
clns
—ISO CLNS
Examples: Static Address Mapping
These sections provide examples of static address mapping for the IP
and IPX protocols.
Two Routers in Static Mode Example
This example illustrates how to configure two routers for static mode.
Configuration for Router 1
interface serial 0
ip address 131.108.64.2 255.255.255.0
encapsulation frame-relay
keepalive 10
frame-relay map ip 131.108.64.1 43