AIS Router AI2524 User Manual
Page 391
Chapter 16: Basic Configuration
August 1997
Page 16-15
2524UM
1.
Enter enable mode:
Router> enable
password: enablepassword
2.
Enter configuration mode:
Router# config term
Router(config)#
3.
Assign an IP address to the serial port on the module:
Router(config)# interface serial port_number
Router(config-if)# ip address ipaddress suLnetmask
Router(config-if)# no keepalive
4.
Set the network type to switched:
Router(config-if)# service-module 56k network-type switched
5.
Set the carrier type, where carrier can be ttt, sprint, or other:
Router(config-if)# service-module 56k switched-carrier carrier
6.
Enter the dialer information:
Router(config-if)# dialer in-band
Router(config-if)# dialer string targetrouter_phonenumber
Router(config-if)# dialer-group~ groupnumber
Router(config-if)# exit
Router(config)# dialer-list groupnumber protocol protocol permit
Router(config)#
7.
Return to user EXEC mode:
Router(contlg)# exit
Router# exit
Router
>