ADS Technologies NetDSL 800 ADSL Modem version 5.2b1 - Manual (Page 32)

Configuration
5-2 NetDSL Software User’s Guide
5.2 Outline of Configuration
With the Configuration feature you have the flexibility to configure one
parameter at any time and to change more technical default settings. The
Configuration window is organized in a hierarchical tree format. From the
NetDSL Manager, click General Configuration to access the General
Configuration window. Click on the item that you wish to configure, and then set
the parameters.
General Configuration
• Administrative Security: Sets your modem’s name and enables
password protection (optional).
• Bridge Packet Filtering Table:Monitors and selectively filters
packets that enter or leave the NetDSL.
LAN Configuration
• LAN Configuration: Allows you to set the primary and secondary IP
addresses and Subnet Mask information for the LAN.
DSL Configuration
• ATM PVC Properties: Allows you to specify the name of the ATM
Permanent Virtual Circuit (PVC), and the values of Virtual Path
Identifier (VPI) and Virtual Channel Identifier (VCI).
• ATM Service Type: Allows you to choose the ATM service category
supporting your ATM connection and the rate parameters associated
with the service: Unspecified Bit Rate (UBR) and Constant Bit Rate
(CBR). From this panel you can specify the Peak Cell Rate (PCR) in
kbps, and you can set the Operations and Maintenance (OAM) F5
timer period. If the period is set to zero, the OAM F5 loopback cell
will not be sent. If the period is non-zero, the loopback cell is sent
according to the specified period to the remote peer.
Configuration File
• Save Configuration File: Saves your customized configuration
settings to your local hard disk drive as a configuration file (*.cfg).
This is especially helpful for network management.
• Load Configuration File: Allows you to load any previously saved
configuration file.