AMCC 3WARE 720-0138-00 - Manual (Page 32)

Chapter 3. 3DM 2 (3ware Disk Manager) Introduction
24 3ware Serial ATA RAID Controller User Guide for the Power Mac G5
Setting Up 3DM Preferences
The 3DM 2 Settings page lets you define preference settings that affect the
overall operation of 3DM. Most of these settings are specified initially during
installation of 3DM.
On the 3DM 2 Settings page you can perform the following tasks:
•
Setting and Changing 3DM Passwords
• Managing E-mail Event Notification
• Enabling and Disabling Remote Access
• Setting the Incoming Port #
• Setting the Frequency of Page Refreshes
Maintenance page Lets you configure new units and make changes to
existing units.
To view this page, choose Management > Maintenance
from the menu bar.
Alarms page Shows a list of alarms, including the specific alarm
message, and the exact date and time it occurred.
To view this page, choose Monitor > Alarms on the menu
bar.
Battery Backup page Shows the status of a Battery Backup Unit (BBU), if one is
installed, and allows you to test the battery.
To view this page, choose Monitor > Battery Backup on
the menu bar.
(BBUs are not supported on the 9590SE-4ME.)
Enclosure Summary
page Lists the enclosures attached to your 3ware controller.
To view this page, choose Monitor > Enclosure
Support on the menu bar.
Enclosure Details
page Shows details about a particular enclosure, including
status information. You can also use this page to blink the
LED for a particular drive.
To view this page, click the ID number of the Enclosure on
the Enclosure Summary page.
3DM 2 Settings page Lets you set preferences, including email notification for
alarms, passwords, page refresh frequency, whether
remote access is permitted, and the incoming port which
3DM will use for listening.
To view this page, click 3DM 2 Settings on the menu bar.
Table 5: List of 3DM Pages
3DM Page Description