Aiwa HT-DV1 - Manual (Page 7)

ENGLISH
7
INTRODUCTION
En
Remote control
Before using the remote control
A battery (CR2025) is already installed in the remote control
when shipped from the factory.
Remove the insulating tape from the battery holder by
pulling its end as shown below.
When to replace the battery
The maximum operating distance between the remote
control and the remote sensor of the system is
approximately 5 meters. If the operating range decreases,
replace the battery with a new one.
How to replace the battery
Insert a ballpoint pen or similar pointed tool in the notch of
the battery holder at the bottom, and then slide out the
battery holder. Place a new battery (CR2025) into the
battery holder with correct polarity. Finally, push the holder
back into position.
NOTES
• When operating with the remote control, point the top of
the remote control toward the DVD player.
• If the system is not going to be used for an extended
period of time, remove the battery to prevent possible
electrolyte leakage.
• The remote control may not operate correctly when:
- There is an intense light, such as sunlight, in the line
of sight between the remote control and the DVD player.
- There is fluorescent lighting near the remote sensor.
- Other remote controls are used nearby (those of a TV
set, etc.).
CAUTION
• Lithium battery (CR2025) for the remote control
Replace the battery with Hitachi Maxell or Panasonic,
Part No. CR2025 only. Use of another battery may
present a risk of fire or explosion.
The battery may explode if mistreated. Do not
recharge, disassemble or dispose of in fire.
• Do not keep metallic objects such as rings, bracelets,
and keys near the battery. They may cause the battery
to short circuit.
• After removing the battery, be sure to keep it out of
reach of children. If it is swallowed, consult a doctor
immediately.