Checking the error led, Connecting the network cable – HP UPS Management Modules User Manual
Page 20
Advertising
Installing the HP UPS Management Module 20
Checking the Error LED
If the Error LED illuminates red or flashes red, see the "Troubleshooting (on page
)" section for more
information.
Connecting the network cable
Connect a standard Ethernet cable between the network connector on the management module and a
network jack.
This connection is used to access the management module remotely through telnet or the web interface.
The management module also uses the network connection to communicate to the configured agents and
to facilitate SNMP-based monitoring.
Advertising