Email setup tab – HP UPS Management Modules User Manual
Page 68
HP UPS Management Module web interface 68
2.
For each email and SNMP trap enabled, enter the number of minutes that should pass between the
occurrence of an alert condition and the sending of the notification.
NOTE:
If the event clears before the delay time has expired, then the event notification is not
sent.
3.
Do one of the following:
o
Click Save Settings to save the information.
o
Click Undo Changes to undo the changes.
o
Click Help to view online help.
Email Setup tab
This screen enables administrators to configure email event notifications.
To configure the email notifications:
1.
Enter the mail server IP address in the Email Server Address field.
2.
Enter the email address that messages are marked as being sent from in the From Address field.
3.
Select the Enable Account checkbox and enter up to 10 email addresses in the Email Address field.
The addresses should correspond to the persons who should receive email notifications of events that
occur.
4.
Do one of the following:
o
Click Save Settings to save the information.
o
Click Undo Changes to undo the changes.
o
Click Help to view online help.
5.
Click Send Test Email to send a test email.