HP Surestore 64 Director Switch - Manual (Page 113)

Appendix 101
Appen
d
ix
Error 16: Invalid R_A_TOV The value entered for the resource allocation time-out value is
invalid. The R_A_TOV is entered in tenths of a second and must
be an integer in the range 10–1200 (1 second to 120 seconds).
The R_A_TOV value must be larger than the E_D_TOV value.
Enter a value in the range 10–1200.
Error 17: Invalid E_D_TOV The value entered for the error detect time-out value is invalid.
The E_D_TOV is entered in tenths of a second and must be an
integer in the range 2–600 (0.2 second to 60 seconds). The
E_D_TOV value must be smaller than the R_A_TOV value.
Enter a value in the range 2–600.
Error 18: Invalid TOV The value entered for the time-out value is invalid. Enter a value
in the time-out value range.
Error 20: Invalid Preferred
Domain ID The value entered for the preferred domain ID for the director or
switch is invalid. The preferred domain ID must be an integer in
the range 1–31. Enter a value in the range 1–31.
Error 21: Invalid Switch Priority The value entered for the switch priority is invalid. The switch
priority entered for the director or switch must be
principal ,
default , or neverprincipal (see config.switch.priority on p. 41).
Error 22: Invalid Class 2 VC
Error 23: Invalid Class 3 VC
Error 29: Invalid Gateway
Address The value entered for the gateway address is invalid. The new
gateway address for the Ethernet interface must be entered in
dotted decimal format (for example, 0.0.0.0). Enter the gateway
address for your Ethernet interface in the dotted decimal format.
Error 30: Invalid IP Address The value entered for the IP address for the director or switch is
invalid. The IP address must be entered in dotted decimal format
(for example, 10.0.0.0). Enter the IP address for the director or
switch in dotted decimal format.
Error 31: Invalid Subnet Mask The value entered for the new subnet mask for the Ethernet
interface is invalid. The subnet mask must be entered in dotted
decimal format (for example, 255.0.0.0). Enter the subnet mask
for your Ethernet interface in dotted decimal format.
Message Cause/Solution