HP LaserJet M4349 Multifunction Printer series User Manual
Page 190
Control panel message
Description
Recommended action
41.3 MEDIA TOO SHORT CANNOT SEND
TO FACE DOWN OUTPUT BIN
The MFP cannot deliver the selected media
face-down because the media does not meet
the minimum length specification.
Select the face-up output option, or load a
longer-size media in the tray. Resend the job.
See
.
41.3 UNEXPECTED SIZE IN TRAY XX
LOAD TRAY XX <TYPE> <SIZE>
This is typically caused if two or more sheets
of media stick together in the MFP or if the
tray is not adjusted correctly.
Reload the tray with the correct media size.
Reconfigure the size in a tray so that the MFP
will use a tray that contains the size required
for the print job. Follow the instructions in the
onscreen dialog box.
41.3 UNEXPECTED SIZE IN TRAY XX To
use another tray touch OK
The specified tray is loaded with media that
is longer or shorter in the feed direction than
the size adjusted for the tray.
Touch OK to use another tray. Reconfigure
the size in a tray so that the MFP will use a
tray that is loaded with the size of media
required for the print job. If the message does
not clear automatically from the control-panel
display, turn the MFP off, and then turn the
MFP on.
41.X ERROR To continue touch OK
A temporary printing error occurred.
Touch OK to clear the error. If the error is not
cleared, turn the MFP off, and then turn the
MFP on.
If this message persists, contact your dealer
for support, or go to
49.XXXXX ERROR To continue turn off
then on
A critical firmware error has occurred.
Remove third-party devices. Turn the MFP
off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
50.X FUSER ERROR
A fuser error has occurred.
Make sure you have the correct fuser. Re-
seat the fuser. Turn the MFP off, and then
turn the MFP on.
If this message persists, contact your dealer
for support, or go to
51.XY ERROR To continue turn off then on A temporary printing error has occurred.
Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
52.XY ERROR To continue turn off then on A temporary printing error has occurred.
Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
53.XY.ZZ CHECK RAM DIMM SLOT <X> To
continue touch OK
A problem exists with the MFP memory. The
DIMM that caused the error will not be used.
The following are the values of X:
X = Device location
0 = Onboard memory
1 = Slot 1
You might need to reseat or replace the
specified DIMM.
Turn the MFP off, and then replace the DIMM
that caused the error. See
If this message persists, contact your dealer
for support, or go to
Table 11-1
Control-panel messages (continued)
176 Chapter 11 Problem solving
ENWW