HP LaserJet M4349 Multifunction Printer series User Manual
Page 192
Control panel message
Description
Recommended action
68.X PERMANENT STORAGE FULL To
continue touch OK
The MFP NVRAM is full. Some settings
saved in the NVRAM might have been reset
to the factory defaults. Printing can continue,
but some unexpected functions might occur
if an error occurred in permanent storage.
Touch OK to clear the message. If the
message is not cleared, turn the MFP off, and
then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
68.X PERMANENT STORAGE WRITE FAIL
To continue touch OK
The MFP NVRAM is failing to write. Printing
can continue, but some unexpected functions
might occur if an error occurred in permanent
storage.
Touch OK to clear the message. If the
message is not cleared, turn the MFP off, and
then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
68.X STORAGE ERROR SETTINGS
CHANGED To continue touch OK
One or more MFP settings are invalid and
have been reset to the factory-default
settings. Printing can continue, but some
unexpected functions might occur if an error
occurred in permanent storage.
Touch OK to clear the message. If the
message is not cleared, turn the MFP off, and
then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
69.X ERROR To continue turn off then on A temporary printing error occurred.
Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
79 ERROR To continue turn off then on
A critical hardware error occurred.
Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
8X.YYYY EIO ERROR
The EIO accessory card has encountered a
critical error, as specified by YYYY.
Try the following actions to clear the
message.
1.
Turn the MFP off, and then turn the MFP
on.
2.
Turn the MFP off, reseat the EIO
accessory, and then turn the MFP on.
3.
Replace the EIO accessory.
8X.YYYY INTERNAL JETDIRECT ERROR
The embedded HP Jetdirect print server has
encountered a critical error, as specified by
YYYY.
Turn the MFP off, and then turn the MFP on.
If this message persists, contact your dealer
for support, or go to
Authentication required
Authentication has been enabled for this
feature or destination. A username and
password are required.
Type the user name and password, or contact
the network administrator.
Authentication required to use this
feature
A user name and password are required.
Type the user name and password, or contact
the network administrator.
Bad duplexer connection
The duplex printing accessory is not
connected correctly to the MFP.
Remove and reinstall the duplexer. If this
message persists, contact your dealer for
support, or go to
Table 11-1
Control-panel messages (continued)
178 Chapter 11 Problem solving
ENWW