HP LaserJet M4349 Multifunction Printer series - Manual (Page 75)

5. Touch TCP/IP .
6. Touch IPV4 Settings .
7. Touch Config Method .
8. Touch Manual .
9. Touch Save .
10. Touch Manual Settings .
11. Touch Default Gateway .
12. Touch the Default Gateway text box.
13. Use the touchscreen keyboard to type the default gateway.
14. Touch OK .
15. Touch Save .
Configure TCP/IPv6 parameters
For information about configuring the device for a TCP/IPv6 network, see the HP Jetdirect Print Server
Administrator's Guide.
Disable network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
● It decreases device-generated network traffic.
● It prevents unauthorized users from printing to the device.
● It provides only pertinent information on the configuration page.
● It allows the device control panel to display protocol-specific error and warning messages.
Disable IPX/SPX
NOTE: Do not disable this protocol in Windows-based systems that print to the printer through IPX/
SPX.
1. Scroll to and touch Administration .
2. Scroll to and touch Initial Setup .
3. Touch Networking and I/O .
4. Touch Embedded Jetdirect .
5. Touch IPX/SPX .
6. Touch Enable .
7. Touch Off .
8. Touch Save .
ENWW Network configuration 61