HP LaserJet M4349 Multifunction Printer series - Manual (Page 53)

Menu item Sub-menu item Sub-menu item Values and Description
Link Speed The link speed and communication mode of the print
server must match the network. The available settings
depend on the device and installed print server. Select
one of the following link configuration settings:
CAUTION: If you change the link setting, network
communications with the print server and network
device might be lost.
Auto (default): The print server uses auto-negotiation
to configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails,
either 100TX HALF or 10TX HALF is set depending on
the detected link speed of the hub/switch port. (A
1000T half-duplex selection is not supported.)
10T Half : 10 Mbps, half-duplex operation.
10T Full : 10 Mbps, Full-duplex operation.
100TX Half : 100 Mbps, half-duplex operation.
100TX Full : 100 Mbps, full-duplex operation.
100TX Auto : Limits auto-negotiation to a maximum link
speed of 100 Mbps.
1000TX Full : 1000 Mbps, full-duplex operation.
Print Protocols Use this item to print a page that lists the configuration
of the following protocols: IPX/SPX, Novell NetWare,
AppleTalk, DLC/LLC.
Table 2-10 Jetdirect menus (continued)
ENWW Initial Setup menu 39