HP Photosmart C6340 All-in-One Printer - Manual (Page 204)

Cause: The original was placed incorrectly on the glass.
Fit to Page is not working as expected
Try the following solutions to resolve the issue. Solutions are listed in order, with the most
likely solution first. If the first solution does not solve the problem, continue trying the
remaining solutions until the issue is resolved.
• Solution 1: Scan, enlarge, and then print a copy
• Solution 2: Place the original correctly on the glass
• Solution 3: Wipe the glass and the back of the document lid
Solution 1: Scan, enlarge, and then print a copy
Solution: Fit to Page can only enlarge the original up to the maximum percentage
allowed by your model. For example, 200% might be the maximum enlargement
percentage allowed by your model. Enlarging a passport photo by 200% might not
enlarge it enough for it to fit a full-size page.
If you want to make a large copy of a small original, scan the original into the computer,
resize the image in the HP scanning software, and then print a copy of the enlarged
image.
Cause: You were trying to increase the size of an original that was too small.
If this did not solve the issue, try the next solution.
Solution 2: Place the original correctly on the glass
Solution: Load the original print side down on the right front corner of the glass as
shown below.
Cause: The original was placed incorrectly on the glass.
If this did not solve the issue, try the next solution.
Copy troubleshooting 201
Trou
bles
ho
ot
ing