HP Photosmart C6340 All-in-One Printer - Manual (Page 41)

3. Press the down arrow button until View Network Settings is highlighted, and then
press OK.
4. Do one of the following:
•
To display wired network settings, press the down arrow button until Display
Wired Summary is highlighted, and then press OK.
• To display wireless network settings, press the down arrow button until
Display Wireless Summary is highlighted, and then press OK.
• To print the network configuration page, press the down arrow button until
Print Network Configuration Page is highlighted, and then press OK.
Related topics
“Network configuration page definitions” on page 42
Restore network defaults
You can reset the network settings to what they were when you purchased the HP All-in-
One.
CAUTION: This will erase all wireless setup information that you have entered. In
order to restore this information, you will need to run the Wireless Setup Wizard again.
To restore network defaults
1. Press Setup.
2. Press the down arrow button until Network is highlighted, and then press OK.
3. Press the down arrow button until Restore Network Defaults is highlighted, and then
press OK.
4. Press OK to confirm that you want to restore the network defaults.
Turn the wireless radio on and off
In order to stay connected to a wireless network, the wireless radio must stay on. When
the radio is on, the blue light on the front of the HP All-in-One is lit. However, if the HP All-
in-One is connected to a wired network or you have a USB connection, the radio is not
used. In this case you might want to turn the radio off.
To turn the wireless radio on and off
1. Press Setup.
2. Press the down arrow button until Network is highlighted, and then press OK.
Chapter 4
38 Finish setting up the HP All-in-One
Finish set
up