HP Designjet 700 Printer series - Manual (Page 184)

10-2
Company confidential. Postillo/755CM User’s Guide Final Freeze Status:Frozen
This is the cyan on page 10-2 (seq: 182)
This is the black on page 10-2 (seq: 182)
Front-Panel Messages
This is a list of all possible messages in the front-panel display. If you need to do
something, it is shown in italics in the
Explanation and Action column.
The messages are listed in alphabetical order.
Message Explanation and Action
Alignment error
Continue
!
The alignment procedure has failed. Check that an opaque media is loaded.
Press ↓ to continue and force the automatic alignment procedure again by
reseating any of the print cartridges. Do not lift the window while cartridge
alignment is being performed.
Calibrate error
Continue
!
The calibration print was loaded incorrectly and it could not be measured. Press ↓
to continue, then reload the print for measurement. Follow front panel instructions.
Calibration done
Continue
!
Accuracy calibration is complete. Press ↓ to continue.
Close roll cover
Continue
!
Rewind the media to take up any slack in the roll, close the roll cover, then press
↓ to continue.
Create pattern
!
Measure pattern
!
Press ↑ to create the pattern for automatic calibration.
Press ↓ to stat the automatic calibration.
Edge not found
Reload media The printer could not find edge of media during loading procedure. Check the
leading edge of the media for unevenness or tears; cut a straight edge, if
necessary, and reload. Be sure to position the right edge along the perforated line
on the entry platen when loading.
Lift lever Lift the lever at the right of the printer.
Load arrow edge
print side down Remove accuracy calibration print, turn it so that the edge with arrows printed on
it is print side down, then load that edge into the printer.
Load cancelled
Remove media You pressed the Cancel button while media loading was in progress. Remove
media.
Load error
Remove media You inserted media with the media lever raised. Lower the lever and reload the
media.
Load media
to align cartridges Load media to proceed with cartridge alignment.
Lower lever
after aligning When you’ve finished aligning the roll media as instructed, lower the lever at the
right of the printer.
Front-Panel Messages