HP Designjet 700 Printer series - Manual (Page 26)

1-8
Company confidential. Postillo/755CM User’s Guide Final Freeze Status:Frozen
This is the cyan on page 1-8 (seq: 24)
This is the black on page 1-8 (seq: 24)
Task 3: Load Media
For advice on the availability and use of different media types, see the section
starting on page 3-2.
IMPORTANT Because the next task is to load the cartridges and carry out the
automatic cartridge alignment procedure, you must load opaque media at this stage
– for example, coated paper – as this is needed for the alignment procedure.
Either of the rolls supplied with the printer is suitable.
To load roll media, start with step 1 below.
To load sheet media, go to page 1-15.
To Load a Roll
1 Make sure the printer wheels are locked (the brake levers pressed down) to prevent
the printer from moving.
2 Open the roll cover and remove the empty spindle by pulling firmly on each
end. The two ends are different: end A has a media stop and end B a smaller
endcap, as shown on the next page.
A
B
Roll cover
Place the spindle vertically on the floor, with the media stop at the bottom,
ready for the new roll.
1865
Setting Up the Printer
Task 3: Load Media