HP Designjet 700 Printer series - Manual (Page 96)

3-26
Company confidential. Postillo/755CM User’s Guide Final Freeze Status:Frozen
This is the cyan on page 3-26 (seq: 94)
This is the black on page 3-26 (seq: 94)
Before Replacing Cartridges
Four important points:
1 Your printer is designed to operate only with the four cartridge types whose
specific part numbers are listed on page 11-15. Except on glossy media types, the
printer will operate successfully in monochrome with just the black cartridge
loaded, although the
Best print quality may not be as good as if all cartridges were
loaded. Otherwise, all four must be loaded.
2 Every time you replace, or even adjust, a cartridge, the printer afterwards runs an
automatic alignment procedure, for which it needs an opaque media type, for
example opaque bond (regular printer paper) or coated paper. So make sure that
either a roll or a sheet of the appropriate media is loaded before you replace a
cartridge. If the automatic cartridge alignment procedure is not run on a suitable
media type, print quality will be affected.
3 Once the cartridges have been installed they should not be removed, except to
replace them. This will ensure the best lifetime for your cartridges.
4 Make sure you are aware of the general warnings and caution below.
Don’t touch the stainless steel strip that runs the length of the printer behind
the cartridge carriage; its edge is very sharp. Keep hair, jewelry, clothing,
and foreign objects away from the printer mechanisms. Keep new and used
print cartridges out of the reach of children.
Only touch the plastic parts of the cartridge. Do not touch, wipe, or attempt to
clean the cartridge nozzles or contacts as they can become clogged or
scratched and are easily damaged.
Each time you access the cartridges to load or reseat them, the nozzles are
exposed to air. If the nozzles are exposed to air (except during printing) for
more than a few minutes at a time, they are susceptible to clogging and
drying.
It is absolutely essential to load the cartridge(s) in the correct stalls, or your
colors will be wrong and print quality may be impacted.
Working with Media and Cartridges
Replacing Cartridges
W A R N I N G
C A U T I O N
C A U T I O N
C A U T I O N