HP Designjet 700 Printer series - Manual (Page 185)

10-3
Company confidential. Postillo/755CM User’s Guide Final Freeze Status:Frozen
This is the cyan on page 10-3 (seq: 183)
This is the black on page 10-3 (seq: 183)
Message Explanation and Action
Lower lever
to continue You lifted the media lever while the processor was busy. Lower the lever to
continue.
Lower window
to continue You opened the window while the processor was busy. Close the window to
continue.
Media too small The media you loaded for accuracy calibration or cartridge alignment is too small.
Reload appropriate media. See page 7-5.
Mispositioned
Reload roll The roll is mispositioned. Reload media.
Mispositioned
Reload sheet The sheet is mispositioned. Remove it and reload it with the right edge no more
than 0.2 inches (0.5 cm) from either side of the perforated line on the entry platen.
MIO data error You configured the modular interface incorrectly. Press Enter to clear the message
from the front panel display. Recheck the MIO configuration settings.
MIO error
Communication
break You prematurely stopped the flow of data from the computer to the printer (e.g., by
turning off the computer before all data is sent).
Press Enter to clear the message
from the front panel display.
Open window to
access cartridges Lift the window to access the cartridges.
Out of memory
Data was lost The current file is too large for the printer’s buffer. See the note on page 9-22.
Pull
#
/ Align
$
edges to roll
Grasp the left and right free edges of the roll media and pull toward you until the
media is taut. At the same time, align the left and right edges of the media so that
they are flush with the left and right edges of the roll.
Remove media
Continue
!
The ink is dry. Remove the accuracy calibration print the printer just produced.
Press ↓ to continue with accuracy calibration.
Remove media
Lower lever You have attempted to load media while the lever at the right of the printer was
raised.
Remove the media, lower the lever, and reload media with the lever down.
Replace cartridge(s)
EEE E
The cartridge indicated has a clogged nozzle. Replace it to continue.
Reseat cartridge(s)
EEE E
The cartridge indicated is badly seated. R eseat it to continue.
Roll misaligned
Reload roll Roll media is skewed. Reload media.
RS-232 error
Baud, parity You configured the RS-232-C interface incorrectly. Press Enter to clear the
message from the front panel display. Check the baud rate and parity settings in
the front panel, in the hardware configuration, and in your software to be sure they
are all compatible.
MESSAGES
10
Front-Panel Messages