HP Designjet Z6200 Photo Printer - Manual (Page 145)

The benefits of arranging a service engineer's visit when these messages appear on the front panel are
two-fold:
● The printer components can be replaced at a time that is convenient for you, and so will not
disturb your daily workflow.
● When the service engineer performs a preventive maintenance visit, replaces several parts at
once. This eliminates the need for repeat visits.
Move or store the printer
If you need to move your printer or store it for an extended period of time, prepare it correctly to avoid
possible damage.
1. Do not remove the ink cartridges, printheads or printhead cleaners.
2. Make sure that no paper is loaded.
3. Make sure that the printhead carriage is located in the service station (at the right end of the
printer).
4. Make sure that the Ready message appears on the front panel.
5. Turn off the power by using the Power key on the front panel.
6. Also switch off the power switch at the rear of the printer.
7. Disconnect the power cable and any cables that connect the printer to a network, a computer, or
a scanner.
8. If you have a take-up reel installed, remove the take-up reel sensor and cable-housing unit from the
foot of the printer stand. For your convenience, you can place the sensor and cable-housing unit
on the printer-stand crossbar and use the blue, plastic screw to affix the housing unit to the leg of
the stand, while you move the printer. See the illustration below. When reinstalling the housing
unit, make sure that the wheel on the foot of the printer stand is pointing forward.
NOTE: If the printer or ink cartridges are moved from a cold location to a warm and humid
location, water from the atmosphere can condensate on the printer parts and cartridges and can
result in ink leaks and printer errors. In this case, HP recommends that you wait at least 3 hours
before turning on the printer or installing the ink cartridges, to allow the condensate to evaporate.
TIP: Because preparing and purging the printheads uses both time and ink, you are strongly
recommended to leave the printer always on or in sleep mode, whenever possible, to maintain the
health of the printheads. In both cases, the printer wakes up from time to time to maintain the
printheads. Thus you can avoid going through lengthy preparation processes before using your
printer.
ENWW Move or store the printer 137
Maintain the printer